Aerocel® AeroFit® Elastomeric Insulating Fitting Covers are produced from Aerocel® EPDM Elastomeric Insulation. Aerocel® is a highly efficient thermal insulation that is a flexible, closed-cell, and lightweight EPDM-rubber based elastomeric product. The tightly formed, closed-cell structure of Aerocel® EPDM Elastomeric Insulation makes it an efficient insulation, providing superior insulating capacity to many materials, including other elastomeric insulations.

Aerocel® AeroFit® Insulating Fitting Covers are designed for insulating warm or cold piping fittings without the need to field-fabricate these shapes, saving labor and providing enhanced project performance. Aerocel® AeroFit® Elastomeric Insulating Fitting Covers are supplied in ¼”, 3/8”, 1/2”, 3/4”, 1”, 1-1/4”, 1-1/2” and 2” thickness’, in popular I.D. sizes up to 6” IPS, as copper 90° long-radius and short-radius elbows, and copper refrigeration suction line P-Trap shapes.

KEY FEATURES NOW E84 25/50

4Easy to Install – Lowers Installation Costs,

Increases Project Quality – Keeps Job Costs as

Estimated

4UV Resistant – Added Weather Protection

Not Required, Saves on First Cost and Maintenance

4Lower Thermal Conductivity – Saves Additional

Energy Costs

4257° Upper Use Limit – Greater Application

Range – Cryogenic to Low Pressure Steam

4E 84 25/50 to 2” Thickness – Lowers

Installation Costs with Fewer Layers

4Versatile for Heating, AC, Refrigeration, Solar,

Plumbing – Single Product for All Systems

USES

Aerocel® AeroFit® Elastomeric Insulating Fitting Covers are used to retard heat gain or loss,

and to control condensation formation on cold-water plumbing, chilled water, and

refrigeration line elbows and suction line P-Traps. AeroFit® Elastomeric Insulating Fitting

Covers more efficiently reduce heat flow on hot water plumbing, liquid heating, and

dual-temperature piping fittings by maintaining a full thickness of Aerocel insulation

over the whole surface area of the fitting. Aerocel® AeroFit® Elastomeric Insulating

Fitting Covers avoid the common pitfalls of installation associated with sliding

elastomeric insulation over piping fittings. The recommended service temperature

range for Aerocel Insulation is -297°F to +257°F.